Horizontal surface mounting, Connect the switch to a power source, Horizontal surface mounting -13 – HP 6400CL User Manual
Page 31: Connect the switch to a power source -13
2-13
Installing the Switch
Installation Procedures
In
sta
lli
ng th
e Swi
tch
2.
Hold the switch with attached brackets up to the rack and move it
vertically until rack holes line up with the bracket holes, then insert and
tighten the four number 12-24 screws holding the brackets to the rack.
Horizontal Surface Mounting
Place the switch on a table or other horizontal surface. The switch comes with
rubber feet in the accessory kit that can be used to help keep the switch from
sliding on the surface.
Attach the rubber feet to the four corners on the bottom of the switch within
the embossed angled lines. Use a sturdy surface in an uncluttered area. You
may want to secure the networking cables and switch power cord to the table
leg or other part of the surface structure to help prevent tripping over the
cords.
C a u t i o n
Make sure the air flow is not restricted around the sides and back of the switch.
6. Connect the Switch to a Power Source
1.
Plug the included power cord into the switch’s power connector and into
a nearby AC power source.
2.
Re-check the LEDs during self test. See “LED Behavior” on