HP gnu source-level debugger 5992-4701 - Manual (Page 238)

To save a session to a file:
1. Right-click an empty region of the source or debugger pane.
2. Choose "Save Session to vdb.pid" from the pop-up menu.
The debugger writes the input and output to a file whose name ends in the pid of the
debugger. If you save the session more than once, the new transactions are appended
to the file.
14.32 Support for ddd
GDB works with ddd, the free GDB GUI shell available at http://mumm.ibr.cs.tu-bs.de/.
While this is not formally supported by Hewlett-Packard, these two do work together.
Note however if you have ddd issues, you'll need to report them to the ddd support
channel.
14.33 Support for XDB commands
HP WDB provides support for a subset of XDB commands, enabled with the -xdb
option.
14.33.1 stop in/at dbx commands
The commands and are
equivalent of dbx command. WDB supports
the command in non-dbx mode.
For example:
$ gdb a.out (gdb) stop in main Breakpoint 1 at 0x2a34: file list.c, line 18
from /tmp/a.out (gdb) stop at 25 Breakpoint 2 at 0x2a6c: file list.c, line
25 from /tmp/a.out (gdb)
14.34 GNU GDB Logging Commands
The following commands control GDB logging activities:
• set logging file : Set the current log file
• set logging off : Set logging off
• set logging on : Set logging on
• set logging overwrite[on|off] : Set whether logging overwrites or appends
to the log file.
• set logging redirect [on|off ]: Set the logging output mode
14.35 Support for command line calls in a stripped executable
HP WDB enables you to perform command line calls in a stripped executable.
238 HP-UX Configuration-Specific Information