HP gnu source-level debugger 5992-4701 - Manual (Page 171)

2. The rtcconfig file should contain entries such as the following:
check_heap=on
check_leaks=on
check_free=on
files=exec1:exec2:exec3
output_dir=/tmp/results
3. Set the following environment variables as follows:
export BATCH_RTC=on
4. Complete one of the following steps:
— Use the +rtc option for the chatr command on each of the required
executable files that must be instrumented, as follows:
$ chatr +rtc enable exec1 exec2 exec3
OR
— Preload the librtc library as follows:
export LD_PRELOAD /opt/langtools/lib/hpux32/librtc.so
5. Run the program as follows:
./exec1
Suppose exec1 eventually spawns exec2, exec3, exec4, exec5, only
exec1
, exec2, exec3 will be instrumented based on the settings in the
rtcconfig file.
14.10.6 Debugging Memory Interactively After Attaching to a Running Process
HP WDB accepts -pid or -p followed by a process ID to attach a running process to
the debugger.
To use Batch RTC after attaching GDB to a running process, complete the following
steps:
14.10 Debugging Memory Problems 171