Harbor Freight Tools DUAL MIG 93793 - Manual (Page 6)

Page 6 For technical questions, please call 1-800-444-3353. SKU 93793
Specific Safety Rules
Ground this product. 1. This Welder
requires the attachment and use
of a UL ® -listed, 240 volt, grounded,
3-prong, electrical Power Cord Plug (not
included). Only a qualified electrician
should install the Power Cord Plug.
Never remove the grounding prong
or modify the Power Cord Plug in any
way. Do not use adapter plugs with this
product. To comply with the National
Electric Code, and to provide additional
protection from the risk of electrical
shock, this product should only be
connected to a 240 volt, 3-hole outlet
that is properly grounded.
Maintain labels and nameplates on
2.
the Welder. These carry important
information. If unreadable or missing,
contact Harbor Freight Tools for a
replacement.
avoid unintentional starting.
3. Make
sure you are prepared to begin work
before turning on the Welder.
Do not force the Welder.
4. This tool will
do the work better and safer at the speed
and capacity for which it was designed.
never leave the Welder unattended
5.
when it is plugged into an electrical
outlet. Turn off the tool, and unplug it
from its electrical outlet before leaving.
Industrial applications must follow
6.
OSha guidelines.
never stand on the Welder.
7. Serious
injury could result if the Welder is
tipped or if hot surfaces are accidently
contacted.
Maintain a safe working environment.
8.
Keep the work area well lit. Make
sure there is adequate surrounding
workspace. Always keep the work area
free of obstructions, grease, oil, trash,
and other debris. Do not use a power
tool in areas near flammable chemicals,
dusts, and vapors. Do not use this
product in a damp or wet location.
9. prevent eye injury and
burns. Wearing and using
ANSI-approved personal
safety clothing and safety
devices reduce the risk for injury.
Wear ANSI-approved safety impact •
eye goggles with a welding helmet with
protective lens.
Leather leggings, fire resistant shoes or
•
boots should be worn when using this
product. Do not wear pants with cuffs,
shirts with open pockets, or any clothing
that can catch and hold molten metal or
sparks.
Keep clothing free of grease, oil,
•
solvents, or any flammable substances.
Wear dry, insulating gloves and
protective clothing.
Wear an approved head covering to
•
protect the head and neck. Use aprons,
cape, sleeves, shoulder covers, and
bibs designed and approved for welding
and cutting procedures.
When welding/cutting overhead or in
•
confined spaces, wear flame resistant
ear plugs or ear muffs to keep sparks
out of ears.
10. Prevent accidental fires.
Remove any combustible
material from the work area.
When possible, move the work to a •
location well away from combustible
materials. If relocation is not possible,
protect the combustibles with a cover
made of fire resistant material.
Remove or make safe all combustible
•
materials for a radius of 35 feet (10