Harbor Freight Tools DUAL MIG 93793 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. SKU 93793
axle BracKet (40)
axle (44)
WaSher (42)
cOtter pIn
(41)
axle BracKet (40)
cOtter pIn
(41)
WaSher (42)
Wheel (43)
caSter (37)
BOttOM panel (36)
BOlt
BOttOM
VIeW
FIGure B
aSSeMBlY InStructIOnS
WarnInG! always turn off the Welder and unplug the unit from its electri-
cal outlet prior to performing any assembly, maintenance, or service.
to attach the handle
Insert the Handle (45) into the Right
Handle Socket (46) and Left Handle
Socket (58). Then attach the Right and
Left Handle Sockets to the Front Panel
(57), using the four Bolts provided.
(See Figure A.)
BOlt
BOlt
BOlt
BOlt
hanDle (45)
rIGht han-
Dle SOcKet
(46)
leFt han-
Dle SOcKet
(46)
FIGure a
to Install the rear Wheels and casters
Insert the two Axle Brackets (40) into the slots located at the rear of the Bottom Panel 1.
(36). Secure the Axle Brackets to the Bottom Panel, using the two Screws provided.
Insert the Axle (44) through the openings (located on the underside of the Bottom Panel)
in the Axle Brackets. Insert one Wheel (43) on each end of the Axle. Insert one Washer
(42) on each end of the Axle. Then secure the two Wheels to the Axle, using one Cotter
Pin (41) on each end of the Axle. (See Figure B.)
Align the four mounting holes in each of the two Casters (37) with the threaded mounting 2.
holes located at the front of the Bottom Panel (36). Then secure the two Casters to the
Bottom Panel, using the eight Bolts provided. (See Figure B.)