Harbor Freight Tools DUAL MIG 93793 - Manual (Page 24)

Page 24 For technical questions, please call 1-800-444-3353. SKU 93793
When the Weld is completed
Lift the Welding Wire completely away from any grounded object. Set the face shield 21.
down. Then, turn the Power Switch to its “OFF” position.
Unplug the Power Cord (54) from the electrical outlet. Then, make sure to set the 22.
Welding Torch (51) on a nonflammable, nonconductive surface.
nOte:
23. A wire brush/hammer (not included) can now be used to clean up the weld.
24. cautIOn! The weld may still be quite hot, and sparks/chips may fly when
cleaning. Make sure to continue wearing ANSI-approved safety impact eye
goggles and other protective wear when cleaning a weld.
The hammer can be used to knock off any excess spatter and to help knock down any a.
ridges. Make sure not to damage the weld or material when striking it.
The wire brush can then be used to help remove oxidation and some fine spatter.
b.