Harbor Freight Tools DUAL MIG 93793 User Manual

Page 26

Page 26

For technical questions, please call 1-800-444-3353.

SKU 93793

Remove the four Screws (51l) holding

the Torch Housings (51j & 51k) together.

Set Housings and Screws aside.
Remove the four Screws (15g) that hold

the Cable Clamp (15h) in place. Set

aside the Cable Clamp, Screws, and the

black sleeve on the liner underneath the

cable clamp.
Lay torch cable out straight to allow the

cable to twist within the sleeve.
Loosen the Fitting at the end of the Liner

(51g). Once it is detached, remove the

Liner from the gun end.
Install a new Liner and Fitting from the

gun end with the end without a Fitting

first.
Attach the Fitting at the end of the Liner

(51g) through the ring at the end of the

Power Cable (51i) and into the Switch

Box (51d). Tighten securely.
Slide the black sleeve back onto the end

of the liner. Reinstall the Cable Clamp

(15h) and Screws (15g). Trim off the

Liner that extends past the Clamp.

Carefully put the two Torch Housings (51j

10.

& 51k) back onto the torch. Make sure

that all torch parts lay back into place

properly including the Protective Sleeve

(51m), Head Tube (51c), and Trigger

(51e).

See assembly Diagram on

page 31. While all parts are properly in

place, use the four screws to reassemble

the Torch Housings (51j, 51k).
Check the Torch (51) for carefully for

11.

proper operation.
Route the Wire as instructed on page 13.

12.

pleaSe reaD the FOllOWInG careFullY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS

MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES

ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALI-

FIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE

ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR ExPRESSLY

STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED

AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABIL-

ITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS

THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.