Setting up the weld – Harbor Freight Tools DUAL MIG 93793 User Manual
Page 18
Page 18
For technical questions, please call 1-800-444-3353.
SKU 93793
Setting up the Weld
WarnInG!
Before welding, make sure to read and understand all safety precau-
tions and warnings discussed on pages 3 through 10.
VOltaGe cOntrOl KnOB
(55)
WIre SpeeD cOntrOl KnOB
(49)
OVerlOaD InDIcatOr lIGht
(50)
FIGure l
1.
Overload Indicator light (50): If too much current is drawn from the Welder, the
Overload Protector will activate. The
reD Overload Indicator Light will illuminate and the
Welder will automatically turn off until it cools down. If this happens, turn the Power
Switch to its
“OFF” position and wait approximately 20 minutes.
(See Figure l.)
Wire Speed control Knob (49):
2.
The Scale surrounding the Knob is relative value, not
wire feed speed.
(See Figure l.)
Voltage control Knob (55):
3.
The Scale surrounding the Knob is relative value, not
voltage. Adjust the Voltage Control Knob based on thickness of metal being welded.
(See Figure l.)
If using solid-core wire, connect and secure an Argon/ CO
4.
2
gas hose to the rear of the
Welder. (If using flux core wire, protective gas is not required.)
Securely clamp the Ground Clamp (52) as close as possible to the metal object to
5.
be welded, or to the metal workbench where the object is mounted and electrically
connected.
(See Figure l.)