removing misfed paper, Removing misfed paper – HP AFICIO SP 8100DN User Manual

Page 128

117

9. Removing Misfed Paper

Removing Misfed Paper

An error message appears if a paper misfeed occurs. The error message gives the
location of the misfeed.

R CAUTION:

Important

❒ Misfed paper may be covered in toner. Be careful not to get toner on your

hands or clothes.

❒ Toner on prints made after removing misfed paper may be loose (inadequate-

ly fused). Make a few test prints until smudges no longer appear.

❒ Do not forcefully remove misfed paper, it will tear. Torn pieces remaining in-

side the printer will cause further misfeeds and possibly damage the printer.

❒ More than one misfed area might be indicated. In this case, check every ap-

plicable area. See the following charts shown in the illustration.

❒ If paper continues to misfeed, check the following points.

• Confirm that the setting of the paper size dial matches the size and feed di-

rection of the paper loaded in the paper tray.

• Confirm that the toner cartridge is set correctly.

❒ If paper misfeeds still occur, contact your sales or service representative.
❒ Do not leave any torn paper scraps within the printer.

• The inside of the machine becomes very hot. Do not touch the parts with a

“v” label (means hot surface). Touching a part with a “v” label (means hot
surface) could result in a burn.

• When pulling the paper tray out, be careful not to pull it strongly. If you do,

the tray might fall and cause an injury.

AQV050S