beautypg.com

Printer does not print, 8printer does not print – HP AFICIO SP 8100DN User Manual

Page 112

background image

Printer Does Not Print

101

8

Printer Does Not Print

If printing still does not start, contact your sales or service representative. Con-
sult with the store where the printer was purchased for information about the
location of sales or service representatives.

Possible Cause

Solutions

Is the power on?

Confirm that the cable is securely plugged into the power outlet
and the printer.

Turn on the power.

Does the Online indicator
stay on?

If not, press the {Online} key to light it.

Does the Alert indicator
stay red?

If so, check the error message on the display and take the required
action.

Is paper loaded?

Load paper into the paper tray or onto the bypass tray.

See p.71 “Loading Paper”.

Can you print a configura-
tion page?

If you cannot print a configuration page, it probably indicates a
printer malfunction. Contact your sales or service representative.

See “Printing the Test Page”, Quick Installation Guide.

Is the interface cable con-
nected securely to the
printer and the computer?

Connect the interface cable securely. If it has a fastener, fasten it
securely as well.

Are you using the correct
interface cable?

The type of interface cable you should use depends on the compu-
ter you use. Be sure to use the correct one.

If the cable is damaged or worn, replace it with a new one.

See p.134 “Specifications”.

Is the Data In indicator
blinking or lit after starting
the print job?

If not blinking or lit, the data is not being sent to the printer.

If the printer is connected to the computer using the in-

terface cable

Check the port connection setting is correct. For details about
checking the port connection, see p.102 “Checking the port
connection”.

Network Connection

Contact your network administrator.

How is the signal strength
when using the wireless
LAN?

Ad hoc Mode or 802.11 Ad hoc Mode

Either move to a location where the signal is good, or remove
obstructions.

Infrastructure Mode

Check the signal status from the “Maintenance” menu on the
control panel. If the signal is poor, either move to a location
where it is good, or remove obstructions.