Fibre channel logical unit control mode page – HP C737990900 User Manual
Page 86
86 Commands
None of the fields in this mode page are changeable.
Fibre Channel Logical Unit Control Mode Page
This page is supported for Fibre Channel only:
Maximum Additional
Partitions
0 Zero is returned, indicating that no additional partitions are present or
supported.
Additional Partitions
Defined
0 Zero must be returned, indicating that no additional partitions are present
or supported.
FDP
0 The Fixed Data Partitions bit is not supported and must be set to zero.
SDP
0 The Select Data Partitions bit is not supported and must be set to zero.
IDP
0 The Initiator Defined Partitions bit is not supported and must be set to zero.
POFM
0 The Partitions on Format bit is set to zero since the drive does not support
the
FORMAT MEDIUM
command through which the tape could be
partitioned.
CLEAR
0 Set to zero indicating SCSI-2 compatibility.
ADDP
0 Set to zero indicating SCSI-2 compatibility.
Medium Format
recognition
3 This indicates that the drive is capable of format and partition recognition.
PSUM
3 Partition Size Unit of Measure: The value of 11b indicates that the units of
measure for the Partition Size descriptor are defined by the Partitions Units
field: 10
(Partition Units)
bytes.
Partition Units
9 This defines the units of the Partition Size field as 10
9
bytes, in other words
in gigabytes.
Partition Size
100 Gen 1 tape loaded
200 Default value. No data cartridge present or Gen 2 tape loaded.
7
6
5
4
3
2
1
0
0
PS (0)
Rsvd (0)
Page Code {18h}
1
Page Length {06h)
2
Reserved (0)
3
Reserved (0)
EPDC[1]
4–7
Reserved (0)