HP C737990900 - Manual (Page 138)

138 Commands
29 02h
SCSI bus reset SCSI drives: The drive has received a SCSI reset signal
since the host last accessed it.
FC drives: The drive has received its first process login.
The drive will be implicitly logged out after a Target Reset
so this ASCQ will be posted after the host has performed
port/process login.
29 03h
Bus device reset SCSI drives: The drive has received a SCSI bus device
reset message since the host last accessed it.
FC drives: The drive has received a process login when it
was previously logged in for a particular host.
29 04h Internal firmware reboot The drive has reset itself.
29 05h Transceivers to SE
SCSI drives: The transceivers on the bus have been reset
to Single-Ended.
29 06h Transceivers to LVD
SCSI drives: The transceivers on the bus have been reset
to LVD.
2A 01h Mode parameters changed
The Mode parameters for the drive have been changed
by an initiator other than the one issuing the command.
30 00h Incompatible medium installed
A write-type operation could not be executed because it is
not supported on the type of tape that is loaded.
30 01h Unknown format
An operation could not be carried out because the tape in
the drive is of a format not supported by the drive.
30 02h Cannot read media: incompatible format
An operation could not be completed because the logical
format is not correct.
30 03h Cleaning cartridge installed
An operation could not be carried out because the tape in
the drive is a cleaning cartridge.
30 04h Cannot write medium
An attempt was made to write to a cartridge that has
Cartridge Memory errors.
30 07h Cleaning failure
A cleaning operation was attempted but could not be
completed for some reason.
31 00h Medium format corrupted
Data could not be read because the format on tape is not
valid, although it is in a known format.
35 01h Unsupported enclosure function
The drive cannot respond to this Enclosure Services
request.
35 02h Enclosure services unavailable
No compatible enclosure hardware has been detected by
the drive.
37 00h
Rounded parameter A MODE SELECT command parameter has been rounded
because the drive cannot store it with the accuracy of the
command.
3A 00h Medium not present
A media-access command has been received when there
is no tape loaded.
3A 04h Media Auxiliary Memory not ready to access MAM is not ready to be accessed. This is likely to be
because there is no cartridge present.
Code Description Explanation