Extron electronic 3000B - Manual (Page 89)

Exatron 3000B
www.exatron.com 5-10 Chapter 5 Diagnostics
; ; ; ;
Solenoid Check
__________________________________________________________________
This diagnostic tests port 03, located on PCB #5000-398, PAL 398-72, U5, U6.
TO ENTER THIS CHECK:
Handler displays DIAGNOSTICS
Press the [2] key.
Handler displays SOLENOID CHECK
Please refer to the following table. Press each of the handler terminal’s keypad keys [0] through [9].
Each key will turn on/off the handler's output cover LEDs and will set the corresponding handler solenoid
into an on/off test cycle. Please refer to Changeover Kit Supplement for specific solenoid information.
Terminal Output Corresponding
Key: Cover LED: Override Switch:
[1] Solenoid #1 __________ 1 YELLOW BUTTON
[2] Solenoid #2 __________ 2 WHITE BUTTON
[3] Solenoid #3 __________ 3 ORANGE BUTTON
[4] Solenoid #4 __________ 4 BLACK BUTTON
[5] Solenoid #5 __________ 5 GREEN BUTTON
[6] Solenoid #6 __________ 6 GREY BUTTON
[7] Solenoid #7 __________ 7 RED BUTTON
[8] Solenoid #8 __________ 8 BLUE BUTTON
[9] All Solenoids ON ALL On
[0] All Solenoids OFF ALL Off
Pressing the [Clear] button will flash the terminal's displayed message to confirm the handler is still in this
specific diagnostic check.
Press the [Enter] button to EXIT this diagnostic check and return to the DIAGNOSTICS message.