Explore Scientific 7-in-1 Sensor for 7-in-1 Wi-Fi Weather Station - Manual (Page 9)

9
EN
Step 2:
Fasten the stainless steel pole on
your fix pole (purchase separately)
with U-bolts, pole mounting clamps
and nuts.
Fixed pole
(not included)
MOUNTING POLE AND DIRECTION ALIGNMENT
Install the wireless 7-IN-1 sensor in an open
location with no obstructions above and around the
sensor for accurate rain and wind measurement.
Install the sensor with the smaller end facing the
North to properly orient the wind direction vane.
Secure the mounting stand and bracket (included)
to a post or pole, and allow minimum 1.5m off the
ground.
Point to
NORTH
1.5 meter
off the
ground
Fixed pole
package not
included
Add rubber
pad before
mounting on
pole or post
Install the wireless 7-IN-1 sensor in an open location
with no obstructions above and around the sensor for
accurate rain and wind measurement. Install the sensor
with the smaller end facing the North to properly orient
the wind direction vane. Secure the mounting stand and
bracket (included) to a post or pole, and allow minimum
1.5m off the ground.
Add rubber
pad before
mounting on
pole or post 1.5 meter
off the
ground
Fixed pole
(not included)
Point to
NORTH
INSTALL WIRELESS INDOOR SENSOR
1. Remove the battery door of the sensor.
2. Use the channel slide switch to set the channel number for the
sensor (e.g. Channel 1)
3. Insert 2 x AA size batteries into the battery compartment and close
the battery door according to the polarity information marked on the
battery compartment.
4. The sensor is in synchronization mode, and can be registered to the
console within the next few minutes. The transmission status LED
will begin to flash every 1 minute.
NOTE:
-If you need to re-assign the sensor channel, slide the channel slide switch to the new channel
position. For the new channel number to be effective, press [ RESET ] key on the sensor.
- Avoid placing the sensors in direct sunlight, rain or snow.
-To avoid the sensor/s and console pairing failure during new console setup, please power up
the sensor/s first, and then press [ RESET ] key on the main unit (no need on sensors).
PLACING THE WIRELESS INDOOR SENSOR
Place a screw on the wall that you wish to hang the sensor on.
Hang the sensor onto the screw by the wall mounting holder. You
can also place the sensor on a table by itself.
SETUP THE CONSOLE
POWER UP THE CONSOLE
1. Plug the adapter provided to the power jack at the back of the console.
2. Once the console is turned on, all the segments of the LCD will be shown momentarily.
3. The console will automatically enters sensor synchronization mode and AP mode (refer to
SETUP WI-FI CONNECTION ).
NOTE:
If no display appears on the LCD after you plug the adaptor, press [ RESET ] key by using a
pointed object.
SYNCHRONIZING WIRELESS 7-IN-1 SENSOR AND INDOOR SENSOR(S)
Immediately after power up, while still in Synchronization mode, the 7-in-1 sensor and Indoor
Sensor can be paired to the console automatically. Once your sensors are paired up, the
sensors' signal strength indicator and weather reading will appear on your console display.
BACKUP BATTERY
Backup batteries are used to keep time-sensitive information on the console’s memory during
power failure. These include:
- Time & Date, Alarm Time, Max/Min & Past 24 hours weather records, Alert setting values,
Sensor(s) channel history, and Units