Explore Scientific 7-in-1 Sensor for 7-in-1 Wi-Fi Weather Station - Manual (Page 20)

20
When clock reach the alarm time, alarm sound will start.
Where it can be stopped by following operation:
-Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in
the next day.
-By pressing [ALARM / SNOOZE] key to enter snooze that the alarm will sound again after 5
minutes.
-By pressing and hold [ALARM / SNOOZE] key for 2 seconds to stop the alarm and will
activate again in the next day
-By pressing [ ALARM ] key to stop the alarm and the alarm will activate again in the next day.
NOTE:
-The snooze could be used continuously in 24 hours.
-During the snooze, the alarm icon “ ” will keep flashing.
TEMPERATURE / HUMIDITY FUNCTION
-The temperature and humidity reading are display on the outdoor and indoor (CH) section.
-Use the [ °C / °F ] slide switch to select the temperature display unit.
-If temperature / humidity is below the measurement range, the reading will show “Lo”. If
temperature / humidity is above the measurement range, the reading will show “HI”.
COMFORT INDICATION
The comfort indication is a pictorial indication
based on indoor air temperature and humidity in
an attempt to determine comfort level. Too cold Comfortable Too hot
NOTE:
-Comfort indication can vary under the same temperature, depending on the humidity.
-There is no comfort indication when temperature is below 0°C (32°F) or over 60°C (140°F).
WIRELESS SENSOR SIGNAL RECEIVING
1. The console display signal strength for the wireless sensor(s), as per table below:
Outdoor 7-in-1 sensor
Indoor channel sensor
No signal Weak signal Good signal
2. If the signal has discontinued and does not recover within 15 minutes, the signal icon will
disappear. The temperature and humidity will display “Er” for the corresponding channel.
3. If the signal does not recover within 48 hours, the “Er” display will become permanent. You
need to replace the batteries and then press [ SENSOR / WI-FI] key to pair up the sensor
again.
VIEW THE OTHER INDOOR CHANNELS (OPTIONAL FEATURE WITH ADD ON EXTRA
SENSORS)
This console is capable to pair with a wireless 7-IN-1 sensor and up to 7 wireless indoor
sensors. If you have 2 or more Indoor sensors, you can press [ CHANNEL ] key to switch
between different wireless channels in normal mode, or press and hold [ CHANNEL ] key for 2
seconds to toggle auto-cycle mode to display the connected channels at 4 seconds interval.
During auto-cycle mode, the icon will show on the indoor channel section of the console's
display. Press [ CHANNEL ] key to stop auto cycle and display the current channel.