Explore Scientific 7-in-1 Sensor for 7-in-1 Wi-Fi Weather Station - Manual (Page 7)

7
EN INSTALLATION AND SETUP
Your console can pair up with one wireless 7-in-1 outdoor sensor and up to 7 other wireless
sensors like Thermo/Hygro (ST2001H), Pool/Spa (SP60010) or Soil sensor (SM60020) (sold
separately).
INSTALL WIRELESS 7-IN-1 SENSOR
Your wireless 7-IN-1 sensor measures wind-speed, wind-direction, rainfall, UV, light intensity,
temperature and humidity for you. It’s assembled and calibrated for your easy installation.
INSTALL BATTERIES
Unscrew the battery door at bottom of unit and insert the
batteries according to the +/- polarity indicated. Screw the
battery door compartment on tightly.
NOTE:
- Ensure the water tight O-ring is properly aligned in
place to ensure water resistant.
- The red LED will begin flashing every 12 seconds.
Screw
location
3 x AA
batteries
MOUNTING KIT INSTALLATION
1. U-bolt x 2 2. Pole mounting
clamps x 4
3. Flat washers
x 4
4. Hex nuts
x 4
5. Stainless steel
pole
Note:
Stainless steel pole
placed under the egg
tray, please check before
disposal of the packaging.
Step 1:
Plug the stainless steel pole into
the sensor's mounting hole and
tighten the screws.
Note:
Please make sure that the sensor
has new batteries installed and is
paired up with the console.
Screws