Explore Scientific 7-in-1 Sensor for 7-in-1 Wi-Fi Weather Station - Manual (Page 19)

19
EN MOON PHASE
The moon phase is determined by the
time, date and time zone. The following
table explains the moon phase icons of
the Northern and Southern Hemispheres.
Please refer to POINTING THE
WIRELESS 7-IN-1 SENSOR TO SOUTH
section about how to setup for the
Southern Hemispheres.
Northern
Hemisphere
Moon Phase
Southern
Hemisphere
New Moon
Waxing Crescent
First quarter
Waxing Gibbous
Full Moon
Waning Gibbous
Third quarter
Waning
Crescent
SUNRISE & SUNSET TIME
The console indicates your location’s sunrise & sunset time
by the time zone, latitude and longitude you entered. Please
enter the correct information in the regarding settings. If the
latitude and longitude values do not match the time zone,
the sunrise & sunset time cannot be shown.
SETTING ALARM TIME
1. In normal time mode, press and hold [ ALARM ] key for 2 seconds until the alarm hour digit
flashes to enter alarm time setting mode.
2. Press [ ] or [ ] key to change the value. Press and hold the key for quick-adjust.
3. Press [ ALARM ] key again to step the setting value to Minute with the Minute digit flashing.
4. Press [ ] or [ ] key to adjust the value of the flashing digit.
5. Press [ ALARM ] key to save and exit the setting.
NOTE:
-In alarm mode, the “ ” icon will display on the LCD.
-The alarm function will turn on automatically once you set the alarm time.
ACTIVATING ALARM AND TEMPERATURE PRE-ALARM FUNCTION
1. In normal mode, press [ ALARM ] key to show the alarm time for 5 seconds.
2. When the alarm time displays, press [ ALARM ] key again to activate the alarm function.
Or press [ ALARM ] key twice to activate the alarm with ice pre-alarm function.
Alarm off Alarm on Alarm with ice-alert
NOTE:
Once the ice pre-alert activates, the pre-set alarm will sound and ice-alert icon will flash 30
minutes earlier if the outdoor temperature is below -3°C.