Serial ports, Rear panel rs-232 port, Front panel configuration port – Extron electronic Fiber Optics Fox 4G DA8 User Manual
Page 13: Remote control
FOX 4G DA8 • Remote Control
Remote Control
FOX 4G DA8 • Remote Control
3-3
3-2
Serial Ports
The FOX DA has two serial ports that can be connected to a host
device such as a computer running the HyperTerminal utility,
an RS-232 capable PDA, or a control system. These ports make
serial control of the DA possible. The serial ports are:
• The rear panel RS-232 port on a 3-pin captive screw
connector
• The front panel Configuration (RS-232) port, a 2.5 mm
mini stereo jack
The protocol for both ports is as follows:
• 9600 baud
• no parity
• 8 data bits
• 1 stop bit
• no flow control
Rear panel RS-232 port
Do not tin the wires!
Controlling
Device
Ground ( )
Receive (Rx)
Transmit (Tx)
Ground ( )
Receive (Rx)
Transmit (Tx)
Bidirectional
RS-232
Tx Rx
Function
Pin
TX
RX
Gnd
Transmit data
Receive data
Signal ground
Figure 3-1 — RS-232 connector pin assignments
Front panel configuration port
The optional Extron 9-pin D to 2.5 mm mini jack TRS RS-232
cable, part #70-335-01 (figure 3-2) can be used for connection to
the Configuration port.
6 feet
(1.8 m)
Part #70-335-01
5
1
9
6
Sleeve (Gnd)
Ring
Tip
9-pin D
Connection
TRS Plug
Pin 2
Computer's RX line
Tip
Pin 3
Computer's TX line
Ring
Pin 5
Computer's signal ground
Sleeve
Figure 3-2 — Optional 9-pin TRS RS-232 cable