Elmo P100 - Manual (Page 6)

ENGLISH
55
BEFORE YOU USE
■ The power cord applicable to the local power specifications is attached. Be sure
to use the power cord applicable to your local power specification.
■ Do not leave this product under direct sunlight or by heaters, or this product may
be discolored, deformed, or damaged.
■ Do not place this product in any humid, dusty, windy or vibrating location. Use
this product in the following environmental conditions:
Temperature: 5°C~40°C (41°F~104°F)
Humidity: 30%~85% (No condensation)
■ In handling (including setting up and storing) or carrying the camera, be
meticulously careful not to give an impact on the camera head.
■ To prevent dropping and falling, observe the following:
• Use the camera on a stable stand, desk or table. Never put the camera on
any shaky stand or inclined or instable place.
• Before using, lay out the power cord, the AC adapter cable and the video
cable not to be pulled, and wire them accordingly.
■ Use a soft, dry cloth for cleaning. Do not use any volatile solvent, such as thinner
or benzine.
■ Do not directly point the camera lens into the sun, or the camera may be damaged.
■ Caring for the batteries:
• If this product is not used for a long time, take out the batteries from the
wireless remote control.
• Do not use rechargeable Ni-Cd batteries.
• Do not use new and old batteries, or batteries of different types together.
• Do not try to recharge or short-circuit the batteries.
■ Luminescent and Black Spots
This camera has a CMOS area image sensor and a color LC panel, which are
composed of many pixels. Some of these pixels may not operate normally. As a
result, a luminescent spot or a black spot may appear on the output screen.
However, this is a phenomenon unique to the CMOS area image sensor and
color LC panel and therefore this phenomenon is not faulty.
■ Do not press the LC panel strongly or with a sharp-pointed object, or it would
cause break or failure to the color LC panel.
■ Transfer the data in an SD card to a PC or other data storage means for backup
purpose. Note with care that the data in the SD card could be lost due to failure
or repair of this product.