Elmo P100 - Manual (Page 26)

75
OPERATION PROCEDURE
ENGLISH
Before starting the operation, insert an optional SD card (Option) into the SD card slot on the side panel.
Push it again to remove the SD card.
When loading or unloading the SD card or the power is tuned off, be sure to select the camera image
by pressing the camera button [
] on the front operation panel or wireless remote control and confirm
that the output image has been turned to the camera image beforehand. Otherwise, the SD card
contents could be broken or failure could be caused to the camera.
The SD card is composed of parts vulnerable to static electricity. Therefore, due to the impact of static
electricity, the SD card could malfunction or its contents could be destroyed. When handling the SD
card, take care to avoid static electricity.
The image data viewable on this camera is limited to the image data saved in this camera and the
image data converted on the conversion software attached to this camera.
If the data of the system that is not compatible with this product, a black or gray image will be
displayed.
If the image conversion to the image in the SD card is tried without inserting the SD card, a black image
will be displayed.
After using the SD card, do not leave it inside this product but be sure to remove it.
As an SD card, Panasonic 256MB or 512MB is recommended.
The resolutions of the image to be stored are 1280
× 1024 (SXGA output), 1280 × 720 (HDTV output)
and 1280 × 960 (XGA output).
This product can store images up to 2048 pcs.
ELMO is not liable for any damage caused by the loss of the data in the SD card or passive damage.
Presentation using optional SD card (Option)
SD card