Panasonic LinkRay 70" Class Full HD Commercial LED Display - Manual (Page 49)

49
English
■
[XGA mode]
This menu is displayed at PC IN input.
This unit supports XGA signals (1024 x 768, 1280 x
768, 1366 x 768) having different aspect ratios and
sampling rates.
[Auto]:
Automatically detects the signal.
Switch the setting to suit the input signal for better
display depends on the angle of view or display
resolution condition.
Note
● After making this setting, be sure to make each
adjustment (such as [Auto setup]) on the [Position]
menu as necessary. (see page 38)
■
[Signal range]
This menu is displayed at HDMI1, HDMI2, DIGITAL
LINK and DVI-D IN inputs. Switches the dynamic
range to match the signals from the source connected
to each terminal.
[Video(16-235)]:
If the input signal is the video range
Example: HDMI terminal output for DVD player
[Full(0-255)]:
If the input signal is full range
Example: HDMI terminal output for personal
computer
[Auto]:
Switches the dynamic range automatically between
[Video(16-235)] and [Full(0-255)] according to the
input signal.
Note
● [Auto] can be selected when HDMI or DIGITAL
LINK signal is input.
■
[Input level]
This menu is displayed at PC IN and AV IN inputs.
Adjustment of parts which are extremely bright and
hard to see.
-16 ‒ +16:
(Level low) ‒ (Level high)
■
[3D Y/C filter]
Set this if the video looks unnatural at AV IN input. Set
this to [On] normally.
Note
● Depending on the signalling system, this setting
may be less effective or may not be effective at all.
■
[Colour system]
Sets the colour system according to the signal
method at AV IN input. Set this to [Auto] normally.
This automatically detects the input signal format.
[Auto], [PAL], [SECAM], [NTSC], [NTSC4.43],
[PAL-M], [PAL-N]:
Set this to [Auto] when viewing PAL-60 videos.
When images are unstable
When the system is set to [Auto], images become
unstable in rare case under the condition that the
input signals are at low level or have many noises.
In this case, set the system so it conforms with the
input signal format.
■
[Dynamic backlight control]
Improves picture contrast and alleviates whiteness
by controlling the back light when signals with the low
average brightness level (APL) are input.
[On]:
The function is enabled.
[Off]:
The function is disabled.
Note
● When this function is operating, the on-screen
brightness becomes lower.
● If the [Dynamic backlight control] setting is different
for each input, the on-screen brightness may change
by switching input.
● Depending on the displayed image, the screen may
flicker. If this annoys you, set [Dynamic backlight
control] to [Off].
■
[Frame creation]
( 65-inch model only)
Improves motion picture quality. Select [Off] when the
motion picture looks unnatural.
[Off]:
[Frame creation] is disabled.
[On]:
[Frame creation] is enabled.
Note
● [Frame creation] is a function for 65-inch models.
This function is not available for 55/49/43-inch
models.
■
Input signal display
Displays the frequency and the type of the current
input signal.
60.00 Hz
74.18 MHz
1080/60i
33.72 kHz H-freq.
V-freq.
Dot clock freq.
Signal format
Display range:
Horizontal (15 kHz ‒ 135 kHz)
Vertical (24 Hz ‒ 120 Hz)
The dot clock frequency is displayed when Digital and
PC signal are input.