Recall, Volume adjustment – Panasonic LinkRay 70" Class Full HD Commercial LED Display User Manual
Page 32
English
32
Note
●
Displays the signal name as set in [Input label]. (see
page 51)
●
Input will not be switched unless [Input lock] is set to
[Off]. (see page 73)
●
Image retention (image lag) may occur on the LCD
liquid crystal panel when a still picture is kept on
the panel for an extended period. To prevent such
a problem, using the screensaver and wobbling is
recommended. (see page 50, 55)
RECALL
It is possible to check the setting status of input label,
picture mode, etc.
Press
Current setting status will be displayed.
1
2
7
8
3
4
5
6
HDMI1
16:9
AV IN
Memory name: MEMORY2
Schedule play mode
Off timer
90 min
Backup mode OK
1
Input label
2
Aspect mode (see page 34)
3
Backup input change (see page 70, 71)
4
Audio input (see page 72)
5
Profile name (see page 46)
6
[Schedule play mode] (see page 101)
7
Off timer remaining time (see page 33)
8
Clock / Mute (see page 33, 76)
●
When there is no video signal to the selected input,
[No signal] is displayed for about 30 seconds at the
end.
●
When a USB memory is not connected to the USB
terminal at the time of switching to the USB input, [No
external media] is displayed for about 30 seconds.
Even when a USB memory is connected, if it does not
contain any playable file, [No play file] is displayed at
all times.
●
When [No signal image settings] - [Display setting] is
set to [On] (see page 54), the message [No signal] /
[No external media] / [No play file] are not displayed.
Instead, the image set in [No signal image settings]
will be displayed.
●
To display the clock, set [Date and time] and then set
[Clock display] to [On]. (see page 57, 76)
Volume Adjustment
Press
adjust volume.
INPUT
MENU
ENTER
Unit
20
Volume (SPEAKERS)
●
The current sound volume level is memorised even if
the power is turned off.
●
When [Maximum VOL function] is set to [On], the
volume can only be adjusted to the maximum point
you set, and the displayed value turns red when it
reached its maximum. (see page 73)
●
When [Initial VOL function] is set to [On], the volume
will be at the set level when the display is turned on.
(see page 72)