Bosch VG4-A-PSU1 Power Supply Unit for CCTV Cameras - Manual (Page 9)

Power Supply Units (AUTODOME7000, MIC7000
cameras)
Description | en 9
Bosch Security Systems, Inc. Installation Manual 2020-10 | |
3 Description
This manual describes how to install a VG4-A-PSUx power supply box for an AUTODOME VG5-
camera, or a VG4-A-PSU1 or VG4-A-PSU2 for a MIC7000 camera. Any variations to the
installation procedures are noted.
For AUTODOME cameras, these power supply boxes are intended for use with the VGA-
PEND_ARM Arm Mount, VGA-A-9543 Pipe Mount, and the VG4-A-9230 or VGA-ROOF-MOUNT
Roof Parapet Mount. For complete installation, mounting, and wiring information for
AUTODOME cameras, refer to the VG5 Series AUTODOME Installation Manual included with
the packaging of the AUTODOME pendant.
The table below describes each model of VG4-A-PSU power supply:
Part Number Rating Applicable cameras
VG4-A-PSU1 120 VAC, 60 Hz, 1.2 A AUTODOME cameras;
MIC7000 cameras
VG4-A-PSU2 230 VAC, 50 Hz, 0.6 A AUTODOME cameras;
MIC7000 cameras