Bosch VG4-A-PSU1 Power Supply Unit for CCTV Cameras - Manual (Page 8)

8 en | Unpacking
Power Supply Units (AUTODOME7000, MIC7000
cameras)
2020-10 | | Installation Manual Bosch Security Systems, Inc.
2 Unpacking
This equipment should be unpacked and handled with care. If an item appears to have been
damaged in shipment, notify the shipper immediately.
Verify that all the parts listed in the product's Parts List below are included. If any items are
missing, notify your Bosch Security Systems Sales or Customer Service Representative.
The original packing carton is the safest container in which to transport the unit and must be
used if returning the unit for service. Save it for possible future use.
2.1 Parts List
Each VG4-A-PSU power supply box is NEMA-rated and ships with an enclosure cover and:
–
Two (2) blanking plugs that fit a ½” conduit hole
– Four (4) blanking plugs that fit a ¾” conduit hole
– One (1) Installation Guide
– One (1) Quick Installation Guide (valid for AUTODOME cameras only)
2.2 Optional Parts List
The following table lists the optional equipment for use with the power supply boxes
(applicable
only for models that power AUTODOME cameras):
Option Part Number
Replacement power supply box cover VG4-SBOX-COVER
Analog Multimode Fiber Optic Kit VGA-FIBER-AN
Ethernet Media Converter Kit VG4-SFPSCKT
Note : The fiber optic kits are mounted inside the power supply box. Refer to the individual kit
for installation instructions.
2.3 Tools Required
– Small straight blade screwdrivers ~ 2.5 mm (0.1 in.) – 3.1 mm (1/8 in.)
– Medium straight blade screwdriver
– No. 1 and No. 2 Phillips screwdrivers
– Socket wrench and 9/16 in. socket
– Power drill
– Water tight conduits and fittings that meet NEMA 4 standards