Bosch VG4-A-PSU1 Power Supply Unit for CCTV Cameras - Manual (Page 19)

Power Supply Units (AUTODOME7000, MIC7000
cameras)
Wiring the Power Supply Box | en 19
Bosch Security Systems, Inc. Installation Manual 2020-10 | |
8 Wiring the Power Supply Box
1. Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of the
box.
or
Route the 24 VAC lines through the conduit fitting on the left side of the box.
Notice!
The power supply box with transformer comes with a barrier that separates the high voltage
side on the left from the low voltage 24 VAC side on the right.
2. Cut and trim the high voltage 24/115/230 VAC power and ground wires with sufficient slack
to reach their connector terminal in the box, but not so long as to be pinched by or to
obstruct closing the cover door.
3. Attach the supplied 3-pin power plug to the incoming high voltage power wires in the box.
Refer to connector P101 in
, page 17.
5. Route the low power 24 VAC wires from the right side of the power supply box out to where
the camera will be mounted. Attach the supplied 5-pin 24 VAC Dome plug to the wire ends
inside the box. Refer to connector P107 in
, page 17.