Bosch VG4-A-PSU1 Power Supply Unit for CCTV Cameras - Manual (Page 17)

Power Supply Units (AUTODOME7000, MIC7000
cameras)
Route Wires and Attach Connectors | en 17
Bosch Security Systems, Inc. Installation Manual 2020-10 | |
7.2 Power Supply Box Connections
The following figure is a detailed illustration of the power supply box, which includes the fuse
specifications.
CONTROL
TO DOME
O DOM O DOM
CONTROL
IN/OUT
GND T XD RXD C+ C-
P101
1 2 3
6 5 4 3 2 1 4 3 2 1
P106 P105
P107
XF
1
02
XF103
XF101
5 4 3 2 1
J103 J103 J103 J103
J102
J101 J101J101J101 J101 J101J101 J101 J101 J101 J101 J101 J101J101 J101J101 J101 J101J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101 J101J101 J101 J101 J101J101 J101 J101 J101 J101 J101 J101
(LED)
6 5 4 3 2 1
GND T XD RXD C+ C- XD XD XD XD
H/
A U X DOME
(FUSE)
(F
US
E
)
(F
US
E
)
(F
US
E
)
(FUSE)
(F
US
E
)
(F
US
E
)
(F
US
E
)
(F
US
E
)
(FUSE) (FUSE)
(FUSE) (FUSE)(FUSE)(FUSE) (FUSE) (FUSE)
24V NC 24V
Figure 7.3: Layout of Power Supply Box. (Wire connections applicable for AUTODOME cameras.)
1 Ground Screw 5 Power In
2 Transformer
(115/230 VAC Models) 6 In/Out;
1/2 in. (15 mm) NPS Fitting
3 In/Out to Dome 7 Power In;
3/4 in. (20 mm) NPS Fitting
4 24 VAC to Dome Interface Board 8 Control Data and Video In/Out;
3/4 in. (20 mm) NPS Fitting