Bosch VG4-A-PSU1 Power Supply Unit for CCTV Cameras - Manual (Page 18)

18 en | Route Wires and Attach Connectors
Power Supply Units (AUTODOME7000, MIC7000
cameras)
2020-10 | | Installation Manual Bosch Security Systems, Inc.
!
Warning!
Fuse replacement by qualified service personnel only. Replace with same type fuse.
Fuse Specifications
Volts XF101 Mains XF102 Camera XF103 Heater
24 V T 5.0 A T 2.0 A T 3.15 A
115 V T 1.6 A T 2.0 A T 3.15 A
230 V T 0.8A T 2.0 A T 3.15 A
Power Box Connections - AUTODOME
The following table lists the Power Supply Box connectors for AUTODOME cameras.
No. Connector Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6
Ground Grounding Screw
P101 115/230 VAC Power
In Line NC Neutral
P105 1 Control to Dome
(Fiber Optic Model) C-
(Biphase) C+
(Biphase) Earth
Ground RXD (+)
(RS-232/485) TXD (-)
(RS-232/485) Signal
Ground
P106 1 Control In/Out
(Optional) C-
(Biphase) C+
(Biphase) Earth
Ground RXD (+)
(RS-232/485) TXD (-)
(RS-232/485) Signal
Ground
P107 24 VAC Power to
Dome Plug Dome
24 VAC Dome
24 VAC Earth
Ground Heater
(24 VAC) Heater
(24 VAC)
1. Applicable to VG5 100 and 600 Series AUTODOME cameras only.