Bosch VG4-A-PSU1 Power Supply Unit for CCTV Cameras - Manual (Page 10)

10 en | Pre-installation Check List
Power Supply Units (AUTODOME7000, MIC7000
cameras)
2020-10 | | Installation Manual Bosch Security Systems, Inc.
4 Pre-installation Check List
!
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
Electrical Code
® (NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
and all applicable local codes. Bosch Security Systems accepts no liability for any damages or
losses caused by incorrect or improper installation.
1. Determine the location and distance for the power supply box based on its voltage and
current consumption.
Power
115/230 VAC
Copper Wire To comply with local codes.
Maximum Wire Distances, Power Supply to AUTODOME 600 Series Camera
24 V to AUTODOME camera
VA / Watts 14 AWG
(2.5 mm)
16 AWG
(1.5 mm)
18 AWG
(1.0 mm)
AUTODOME 600, Indoor 27 / 15 129 m (422 ft) 81 m (265 ft) 51 m (167 ft)
AUTODOME 600, Outdoor 55 / 51 63 m (207 ft) 40 m (130 ft) 25 m (82 ft)
Maximum Wire Distances from Power Supply to AUTODOME 7000 HD
24 V to AUTODOME 7000
VA / Watts 14 AWG
(2.5 mm) 16 AWG
(1.5 mm) 18 AWG
(1.0 mm)
HD models with IVA, Indoor 35 / 19 99 m (325 ft) 62 m (205 ft) 39 m (129 ft)
HD models with IVA, Outdoor 60 / 55 58 m (190 ft) 36 m (119 ft) 23 m (75 ft)
2. Use only UL listed liquid-tight strain reliefs for conduits to the power supply box to ensure
that water cannot enter the box. You must use water tight conduits and fittings to meet NEMA
4 standards.
Notice!
Power and I/O cabling must be routed separately inside different permanently earthed metal
conduits.
3. Install all rough wiring, including: power, control, video coax, alarms I/O, relay I/O, and fiber
optic cabling. For video and control protocol methods for AUTODOME cameras, refer to
Video
and Control Cables (AUTODOME VG5-600 Camera Models ONLY), page 20.
4.
For an analog AUTODOME camera only : If you plan to use the RS-232 or RS-485 protocol
to control the camera, refer to Controlling the AUTODOME via the RS232 Protocol, page 24,
or Controlling the AUTODOME via the RS-485 Protocol, page 25, for instructions on
configuring the camera to accept these protocols.