Extron Electronics RGB 400 Series - Manual (Page 22)

RGB 400 Series Templates RGB 400 Series Templates
Templates, cont’d
B-3
RGB 402 and RGB 404 Cut-out Template
Use this template for cutting a hole in a wall or furniture for
the 3-gang size electrical box for an RGB 402 or RGB 404.
The light g
ra
y area represents the la
yout of the
electr
ical
bo
x (3.75"H x 5.60"W) against the rear
of the RGB 402 or RGB 404 front panel.
The dashed line indicates the cut-out
area
(3.95"H
x 5.80"W
)
for
installing
the electr
ical w
all bo
x.
To
install the interf
ace
without
a w
all bo
x,
use the cut-out area (3.00"H)
indicated b
y
the dotted line
.
B-2
All the templates in this section are actual size. Also, they
all include the recommended 0.1” (0.25 cm) clearance on all
sides of the electrical wall box to allow room for the raised
areas surrounding the knockouts.
The dashed line in each template indicates the cut-out area
for installing a wall box. If you plan to install the interface
without a wall box, use the smaller cut-out area indicated
by the dotted lines.
RGB 400 and RGB 406 Cut-out Template
Use this template as a guide for cutting a hole in a wall or
furniture for the 2-gang size electrical box in order to install
an RGB 400 or RGB 406.
The light g
ra
y area represents the la
yout of the
electr
ical
bo
x (3.75"H x 3.75"W) against the rear
of the RGB 400 or RGB 406 front panel.
The dashed line indicates the cut-out
area (3.95"H
x
3.95"W) f
or installing
the electr
ical w
all bo
x.
To
install the interf
ace
without
a w
all bo
x,
use the cut-out area (3.00"H)
indicated b
y
the dotted line
.
Templates