HP E27d G4 27" 16:9 Advanced Docking IPS Monitor - Manual (Page 16)

IMPORTANT: This monitor supports the VESA® industry-standard 100 mm mounting holes. To attach a
third-party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws. Longer
screws might damage the monitor. Be sure that the manufacturer’s mounting solution is compliant with the
VESA standard and is rated to support the weight of the monitor head. For best performance, use the power
and video cables provided with the monitor.
NOTE: This apparatus is intended to be supported by a UL-listed or CSA-listed wall-mount bracket.
Removing the monitor stand
You can remove the monitor head from the stand to install the monitor head on a swing arm or other
mounting fixture.
IMPORTANT: Before beginning to disassemble the monitor, be sure that the monitor is turned off and all
cables are disconnected.
1. Disconnect and remove all cables from the monitor.
2. Position the monitor facedown on a flat surface covered by a protective sheet made of foam or a clean,
dry cloth.
3. Push up on the latch near the bottom center of the stand's mounting plate (1).
4. Swing the bottom of the stand up until the mounting plate clears the recess in the monitor head (2).
5. Slide the stand out of the recess (3).
Attaching the monitor head to a mounting device
To attach the monitor head to a mounting device, follow this procedure.
8 Chapter 2 Setting up the monitor