Eizo DuraVision FDF2382WT-A 23" Multi-Touch Display (Black) - Manual (Page 3)

About This Product
3
About This Product
About the Usage of This Product
• This product is suited to general purposes like creating documents, viewing multimedia
content (Assuming usage of approximately 12 hours per day).
• This product has been adjusted specifically for use in the region to which it was
originally shipped. If the product is used outside the region, it may not operate as
specified in the specifications.
• This product may not be covered by warranty for uses other than those described in this
manual.
• The specifications noted in this manual are only applicable when the following are used:
– Power cords provided with the product
– Signal cables specified by us
• Only use optional products manufactured or specified by us with this product.
About the LCD Panel
• It takes about 30 minutes (under our measurement conditions) for the monitor display to
stabilize. Please wait 30 minutes or more after the monitor power has been turned on,
and then adjust the monitor.
• Monitors should be set to a lower brightness to prevent a loss in the screen quality
caused by long-term use and to maintain stable use.
• When the screen image is changed after displaying the same image for extended
periods of time, an afterimage may remain. Use the screensaver or power save function
to avoid displaying the same image for extended periods of time. An afterimage may
appear even after a short time period has elapsed depending on the displayed image.
To remove such a phenomenon, change the image or keep the power turned off for
several hours.
• If the monitor displays continuously over a long period of time, smudges or burn-in may
appear. To maximize the life of the monitor, we recommend the monitor be turned off
periodically.
• The LCD panel is manufactured using high-precision technology. Although, missing
pixels or lit pixels may appear on the LCD panel, this is not a malfunction. Percentage of
effective dots: 99.9994 % or higher.
• The backlight of the LCD panel has a fixed lifetime. Depending on the usage pattern,
such as usage for long continuous periods, the lifespan of the backlight may run out
sooner, requiring replacement. When the screen becomes dark or begins to flicker,
please contact your local EIZO representative.
• Do not scratch or press on the LCD panel with any sharp objects, at this may result in
damage to the LCD panel. Do not attempt to brush with tissues as this may scratch the
panel.
• (Cautions for the Use of the Touch Panel)
During touch operation
Be careful of the following points. Otherwise, damage may occur to the monitor.
– Do not strongly press, scratch, or poke the touch panel.
– Do not touch the touch panel with hard objects such as ballpoint pens or metals.