Delay, Parameters – Erica Synths LXR Eurorack Drum Module (28 HP) User Manual
Page 19
rat
Compression ratio
1:1 up to 8:1 in dB. Strength of the compression. For
example a ratio of 2:1 will attenuate the volume of a
signal 2dB above the treshold down to 1dB above
the treshold.
atk
Attack
Time it takes for the compressor to kick in.
0.3 to 100ms range
dec
Decay
Time it takes to return to normal gain, after the
input falls below the treshold. 25 to 200ms range.
tre
Treshold
The treshold sets the level at which the compression
effect sets in. -96 to 0dB
gai
Makeup Gain
Compression lowers the volume. Use the output
gain to make up for the difference.
5.4.5. Delay
Straight forward delay FX. Not much to say here. It’s a classic!
Try using the range control for very short delay times and LFO modulation to get some flange
action going!
Parameters
Displayed
name
Name
Description
typ
FX Type
Delay
out
Output routing
Selects the Audio output the FX signal is mixed to.
d/w
Dry / Wet ratio
Mixing ratio between the original and the FX signal.
typ
Delay type
The 4th parameter “type” selects the delay
algorithm to use.
> Del – Mono delay
> Pp – Stereo ping pong delay. The feedback
alternates between the left and right channel. Pan
must be set to a non zero value to work!
tim
Delay time
Adjust the delay time in the range specified by the
range parameter.
rng
Time range
Sets the range for the delay time dial.
The low range is 1ms to 20ms
The high range is 20ms to 0.7sec
ton
tone
Frequency of the lowpass filter in the feedback path.
fbk
feedback
Controls the number of repeats.
LXR Owners Manual
- 19 -