Erica Synths LXR Eurorack Drum Module (28 HP) - Manual (Page 16)

5.3.2. LFO
There are 6 low frequency oscillator. They are basically the same as the audio oscillators, but run at
a lower maximum rate.
The LFO menu is accessed by pressing SHIFT + MOD .
The 6 LFOs can be selected by holding the DRUM button and pushing one of the SELECT
buttons while the LFO menu is active.
Unlike the audio oscillators you can not hear the LFOs directly. They are used to alter other
parameter values over time. For example if you want the filter of a voice to slowly open and close
again, you can use a sine lfo to modulate the filter cutoff.
Displayed
name
Name Description
frq LFO frequency Manual LFO rate control. Only available when sync
is turned off!
off Phase offset When the LFO is retriggered, it is reset to the
selected phase offset.
wav LFO waveform Select the LFO waveform.
• Sine (sin)
• Triangle (tri)
• Saw up (sup)
• Saw down (sdn)
• Square (sqr)
• Random (rnd)
• Exponential saw up (xup)
• Exponential saw down (xdn)
rtg LFO retrigger Allows the LFO to be retriggered from different
sequencer tracks. Select the voice that should
retrigger the LFO (v1-v6) and it will reset its phase
whenever a note is played on the selected track.
Did you know?
You can use the LFO as an additional envelope using the retrigger feature. If set
to the same voice as the modulation destination, the LFO will restart on every
LXR Owners Manual - 16 -