Erica Synths Cymbals Eurorack Module (10 HP) - Manual

CY
B
A
LS
Set the master Tune of Cymbals. This affects both Cymbals
simultaneously, and essentially controls the sample playback rate
Select one of 10 sets of Cymbal samples
These are cymbal “looping”switches. When they are on,
after initial hit, a certain portion of the sample starts to loop
during envelope generator decay until the VCA closes
completely. This creates a feeling of delay applied to the
cymbal. Note that looping works the best on long decay.
Adjust Crash Cymbal decay time manually
Adjust Ride Cymbal decay time manually
This is Tune CV level attenuator
This is Decay CV level attenuator. It effects both
Cymbals simultaneously
Use the manual trigger buttons to check the Cymbal
settings and add some beats during live performance
This is Tune CV input
This is the Accent input. +10V CV will set the Cymbals
to the maximum volume, and it affects both Cymbals
simultaneously. The accent sensitivity is adjustable –
please, refer to instructions in this manual
These are Trigger inputs. The LEDs indicate incoming triggers
These are Decay CV inputs
This is Crash Cymbal output
This is Ride Cymbal output and the Main output of the
module – when nothing is patched in the Crash Cymbal
output, it’s automatically mixed to the Ride Cymbal output
TUNE
SELECT
CRASH LOOP , RIDE LOOP
CRASH DECAY
RIDE DECAY
TUNE CV
DECAY CV
TUNE CV
CR TRIG , RD TRIG
CR D CV , RD D CV
CR OUT
ACC
RD OUT
CR TRIG TUNE CV CR D CV CR OUT
RD TRIG ACC RD D CV RD OUT
TUNE
DECAY CV TUNE CV
RIDE DECAY CRASH DECAY
SELECT
CYBALS
CRASH
LOOP
RIDE
LOOP