Sony Underwater Housing for Select RX100-Series Cameras User Manual

Page 48

This function is not supported by the DWR-R01D and
DWR-R02D.

GP/CH

: Displays the frequency group and channel

configured for the receiver channel.

Frequency

: Displays the frequency configured for the

receiver channel.

…

: Press this button to display the [Group/Channel

Setting] dialog box. You can select the reception
frequency from the channel plan configured for the
receiver in the [Group/Channel Setting] dialog box.

Active Channel Scan

: Press this button to execute the

receiver’s active channel scan function. You can select the
channel for receiving from the detected channels.

Clear Channel Scan

: Press this button to execute the

receiver’s clear channel scan function. You can select the
channel for receiving from the detected channels.

Encryption

: Configure settings for the receiver’s

encrypted communication function.

Codec mode:

Configure settings for the receiver’s codec

mode.

This function is not supported by the DWR-R01D and
DWR-R02D.

BAL Out Level

: Configure settings for the receiver’s

analog audio output level.

This function is not supported on the DWR-R01D,
DWR-R02D, and DWR-R02DN.

Main Out Level:

Adjusts the receiver’s main out level.

This function is not supported on the DWR-R01D,
DWR-R02D, and DWR-R02DN.

UNBAL Out ATT

: Configure attenuator settings for the

UNBALANCED OUTPUT 1/2 connector.

This function is not supported on the DWR-R01D.

Ground Lift

: Configure whether to connect the

GROUND (XLR 1 pin) of the BALANCED OUTPUT 1/2
connector to a chassis GROUND. You can avoid hum,
buzz, and other noise caused by GROUND LOOP by
selecting [LIFT] to lift GROUND (XLR 1 pin) from the
chassis GROUND.

This function is not supported on the DWR-R01D.

AF Output:

Controls the audio output for the receiver

channel. When [MUTING] is selected, audio output
muting will be enabled for the respective receiver channel.
While muting is enabled, the “muting” indicator on the
AF/PEAK level meter will blink red. When
[UNMUTING] is selected, audio output muting will be
disabled for the respective receiver channel.

This function is available under the following conditions.

DWR-R01D:

Version 1.26 or later

DWR-R02D:

Version 1.06 or later

Search TX:

Makes the screens for transmitters that are

paired with the receiver blink.

• This function is not supported on the DWR-R01D,

DWR-R02D, and DWR-R02DN.

• This function is only available on combinations of 3rd

generation or later digital wireless receivers (such as the
DWR-R03D) and digital wireless transmitters (such as
the DWT-B03R). In addition, when using an RMU-01
for Cross Remote connection, the RMU-01 must be
version 1.27 or later.

[Transmitter] menu

Transmitter Type

: In online mode, this setting cannot be

changed. Specify the model of the transmitter paired with
the receiver in offline mode.

Transmitter Name

: Sets the name for the transmitter.

Power save

: Configure settings for the transmitter’s

power-saving function.

RF Power

: Configure settings for the transmitter’s

transmitted power.

• If the maximum transmission power setting of the

transmitter is changed, execute pairing. It may not be
possible to set the transmission power using the wireless
remote control function.

• On 3rd-generation or later digital wireless transmitters

(such as the DWT-B03R), [RF Power] cannot be set to a

Note

Notes