Sony Airpeak S1 Professional Drone - Manual (Page 505)

Help Guide
Digital Camera
ZV-1
TC/UB Settings
The time code (TC) and the user bit (UB) information can be recorded as data attached to movies.
Menu item details
TC/UB Disp. Setting:
Sets the display for the counter, time code, and user bit.
TC Preset:
Sets the time code.
UB Preset:
Sets the user bit.
TC Format:
Sets the recording method for the time code. (Only when [NTSC/PAL Selector] is set to NTSC.)
TC Run:
Sets the count up format for the time code.
TC Make:
Sets the recording format for the time code on the recording medium.
UB Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (TC Preset)
Note
When you rotate the monitor to shoot a self-portrait, the time code and user bit will not be displayed.
How to reset the time code
You can also reset the time code (00:00:00:00) using the RMT-VP1K remote commander (sold separately).
How to set the user bit (UB Preset)
How to reset the user bit
MENU → (Setup) → [TC/UB Settings] → setting value you want to change. 1
MENU → (Setup) → [TC/UB Settings] → [TC Preset]. 1.
Press the top/bottom side of the control wheel, and select the first two digits.
The time code can be set between the following range.
When [60i] is selected: 00:00:00:00 to 23:59:59:29
2.
When [24p] is selected, you can select the last two digits of the time code in multiples of four from 0 to 23 frames.
When [50i] is selected: 00:00:00:00 to 23:59:59:24 *
Set the other digits following the same procedure as in step 2, then press in the center of the control wheel. 3.
MENU → (Setup) → [TC/UB Settings] → [TC Preset]. 1.
Press the (Delete) button to reset the time code (00:00:00:00). 2.
MENU → (Setup) → [TC/UB Settings] → [UB Preset]. 1.
Press the top/bottom side of the control wheel, and select the first two digits. 2.
Set the other digits following the same procedure as in step 2, then press in the center of the control wheel. 3.
505