FujiFilm X-T10 - Manual (Page 151)

135
T
e
ch
nica
l Notes
Cleaning the Image Sensor Cleaning the Image Sensor
Multiple photographs marred by spots or blotches in identical locations may indicate the presence
of dust on the camera image sensor. Clean the sensor using the
V SENSOR CLEANING option in
the setup menu ( P 111); if the problem persists, you can clean the sensor manually as described below.
Note that there will be a charge to repair or replace the image sensor if it is damaged during cleaning.
1 Use a blower (not a brush) to remove dust from the sensor.
Q Do not use a brush or blower brush. Failure to observe this precaution could damage the sensor.
2 Check whether the dust has been successfully removed.
R Repeat Steps 1 and 2 as necessary.
3 Replace the body cap or lens.