Nikon D500 - Manual (Page 203)

203 Technical Notes
Remote
terminal
accessories • Adapter Cord MC-25/MC-25A: Ten-pin to two-pin adapter
cord for connection to devices with two-pin terminals,
including the MW-2 radio control set, MT-2
intervalometer, and ML-2 modulite control set (length
20 cm/8 in.).
• WR Adapter WR-A10: An adapter used to connect WR-R10
wireless remote controllers to cameras with ten-pin
remote terminals.
• GPS Unit GP-1/GP-1A ( 0 143): Record latitude, longitude,
altitude, and UTC time with pictures.
• GPS Adapter Cord MC-35 ( 0 143): This 35 cm (1 ft 2 in.) cable
connects the camera to older GARMIN eTrex- and geko-
series GPS units that conform to version 2.01 or 3.01 of
the National Marine Electronics Association NMEA0183
data format. Only models that support PC interface
cable connections are supported; the MC-35 can not be
used to connect GPS units via USB. The units connect to
the MC-35 using a cable with a D-sub 9-pin connector
provided by the manufacturer of the GPS device; see
the MC-35 instruction manual for details. Before
turning the camera on, set the GPS device to NMEA
mode (4800 baud); for more information, see the
documentation provided with the GPS device.
• Modulite Remote Control Set ML-3: Allows infrared remote
control at ranges of up to 8 m (26 ft 3 in.).