ProSoft Technology MVI71-MCM - Manual (Page 21)

Installing and Configuring the Module MVI71-MCM ♦ PLC Platform
Modbus Communication Module
ProSoft Technology, Inc. Page 21 of 111
December 28, 2007
Address Description Value
N10:27 Port 1 Command Error List Address
N10:28 Port 1 Command Response Timeout
N10:29 Port 1 Retry Count
N10:30 Port 1 Error Delay Count
N10:31 Port 2 Enable
N10:32 Port 2 Type
N10:33 Port 2 Float Flag
N10:34 Port 2 Float Start
N10:35 Port 2 Float Offset
N10:36 Port 2 Protocol
N10:37 Port 2 Baud Rate
N10:38 Port 2 Parity
N10:39 Port 2 Data Bits
N10:40 Port 2 Stop Bits
N10:41 Port 2 RTS ON
N10:42 Port 2 RTS OFF
N10:43 Port 2 Minimum Response
N10:44 Port 2 Use CTS
N10:45 Port 2 Slave ID
N10:46 Port 2 Bit Input Offset
N10:47 Port 2 Word Input Offset
N10:48 Port 2 Bit Output Offset
N10:49 Port 2 Holding Register Offset
N10:50 Port 2 Command Count
N10:51 Port 2 Minimum Command Delay
N10:52 Port 2 Command Error List Address
N10:53 Port 2 Command Response Timeout
N10:54 Port 2 Retry Count
N10:55 Port 2 Error Delay Count
9 If a port is configured as a Modbus Master, you will create Modbus
Commands for that port. For example, if Port 1 is configured as Master N11:0
file would be used as:
Start End Description
N11:0 N11:9 Command 1
N11:10 N11:19 Command 2
N11:20 N11:29 Command 3
N11:30 N11:39 Command 4
N11:40 N11:49 Command 5
… … …
Each Modbus Command has the following structure:
Offset Description
0 Enable
1 Internal
Address
2 Poll Interval
3 Command Count