ProSoft Technology MVI71-MCM - Manual (Page 2)

Please Read This Notice
Successful application of this module requires a reasonable working knowledge of the Rockwell
Automation PLC hardware, the MVI71-MCM Module and the application in which the combination
is to be used. For this reason, it is important that those responsible for implementation satisfy
themselves that the combination will meet the needs of the application without exposing personnel
or equipment to unsafe or inappropriate working conditions.
This manual is provided to assist the user. Every attempt has been made to ensure that the
information provided is accurate and a true reflection of the product's installation requirements. In
order to ensure a complete understanding of the operation of the product, the user should read all
applicable Rockwell Automation documentation on the operation of the Rockwell Automation
hardware.
Under no conditions will ProSoft Technology be responsible or liable for indirect or consequential
damages resulting from the use or application of the product.
Reproduction of the contents of this manual, in whole or in part, without written permission from
ProSoft Technology is prohibited.
Information in this manual is subject to change without notice and does not represent a
commitment on the part of ProSoft Technology Improvements and/or changes in this manual or the
product may be made at any time. These changes will be made periodically to correct technical
inaccuracies or typographical errors.
Warning: This module is not hot-swappable! Always remove power from the rack
before inserting or removing this module, or damage may result to the module, the
processor, or other connected devices.
Power, Input, and Output (I/O) wiring must be in accordance with Class 1,
Division 2 wiring methods, Article 501-4 (b) of the National Electrical Code, NFPA
70 for installation in the U.S., or as specified in Section 18-1J2 of the Canadian
Electrical Code for installations in Canada, and in accordance with the authority
having jurisdiction.
A Warning - Explosion Hazard - Substitution of components may impair
suitability for Class 1, Division 2.
B Warning - Explosion Hazard - When in hazardous locations, turn off power
before replacing or wiring modules.
C Warning - Explosion Hazard - Do not disconnect equipment unless power
has been switched off or the area is known to be non-hazardous.