ProSoft Technology MVI56-S3964R - Manual (Page 31)

Installing and Configuring the Module MVI56-S3964RT ♦ TControlLogix PlatformT
TSiemens 3964R ProtocolT
ProSoft Technology, Inc. Page 31 of 78
2.5.1 Enable
Yes or No
This parameter specifies whether to enable or disable the port. No = Port
Disabled, Yes = Port Enabled.
2.5.2 Baud Rate
300 to 115200
This parameter specifies the baud rate to be used on the port. Valid values are
300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200.
2.5.3 Parity
N, O, E
This parameter specifies the parity setting for this port. Valid values are N =
None, O = Odd, E = Even.
2.5.4 Data Bits
7 or 8
This parameter specifies the number of message data bits. Valid values are 7 or
8 bits.
2.5.5 Stop Bits
1 or 2
This parameter specifies the number of message stop bits. Valid values are 1 or
2 stop bits.
2.5.6 RTS On
Delay (in milliseconds) after RTS before message is sent.
2.5.7 RTS Off
Delay (in milliseconds) after message before RTS dropped.
2.5.8 Use CTS Line
Yes or No
This parameter specifies whether or not to monitor CTS modem line.
2.5.9 Swap
0 or 1
April 17, 2008