ProSoft Technology MVI56-S3964R - Manual (Page 30)

MVI56-S3964RT ♦ TControlLogix PlatformT Installing and Configuring the Module
TSiemens 3964R ProtocolT
Page 30 of 78 ProSoft Technology, Inc.
4 On the Print dialog box, choose the printer to use from the dropdown list,
select printing options, and then click OK.
2.3 [Module]
This section defines the configuration for the Module level data.
2.3.1 Module Name
0 to 80 characters
This parameter assigns a name to the module that can be viewed using the
configuration/debug port. Use this parameter to identify the module and the
configuration file.
2.4 [Backplane 56]
[Backplane 56]
Status Interval: 0 #Minimum interval (ms) between status blocks (0 =
disable)
2.4.1 Block Transfer Size
60
This read-only parameter specifies the number of words in each block transferred
between the module and processor. This value is fixed at 60 words.
2.4.2 Status Interval
Minimum interval (ms) between status blocks (0 = disable)
2.5 [3964R Port x]
This section is used to define the port 1 configuration for the 3964R device
[3964R Port 1]
Enable : Yes #No=Port Disabled,Yes=Port Enabled
Baud Rate : 9600 #Baud rate for port (300, 600, 1200, 2400, 4800,
#9600, 19200, 38400, 57600, 115)
Parity : Even #N=None,O=Odd,E=Even
Data Bits : 8 #7 or 8 data bits for messages
Stop Bits : 1 #1 or 2 stop bits for messages
RTS On : 0 #Delay after RTS set before message sent (mSec)
RTS Off : 0 #Delay after message before RTS dropped (mSec)
Use CTS Line : No #Monitor CTS modem line (Y/N)
Swap : 0 #0=No Data Byte Swapping, 1=Data Byte Swapping
Priority : 1 #0=High Priority, 1=Low Priority
Protocol : 0 #0=3964 RK512, 1=3964
ACK Delay : 1000 #Number of mSec to wait for ACK (Default 1000ms)
Setup Attempts : 1 #Number of times to try to connect to CP (Default 6)
Transmit Attempts : 1 #Number of times to try to transmit to CP (Default 6)
April 17, 2008