beautypg.com

ProSoft Technology MVI69-S3964R User Manual

Page 48

background image

MVI69-S3964R ♦ CompactLogix or MicroLogix Platform

Diagnostics and Troubleshooting

Siemens 3964R Protocol

Page 48 of 80

ProSoft Technology, Inc.

October 31, 2008

Transferring the Configuration File from PC to MVI69 module

Press [R] to send (upload) the configuration file from your PC to the module and
store the file on the module's Compact Flash Disk.

Press [Y] to confirm the file transfer, and then follow the instructions on the
terminal screen to complete the file transfer process.

After the file has been successfully downloaded, the module will restart the
program and load the new configuration information. Review the new
configuration using menu commands [0] and [1] to verify that the module is
configured correctly.

Warm Booting the Module

Caution: Some of the commands available to you from this menu are designed for advanced
debugging and system testing only, and can cause the module to stop communicating with the
processor or with other devices, resulting in potential data loss or other failures. Only use these
commands if you are specifically directed to do so by ProSoft Technology Technical Support staff.
Some of these command keys are not listed on the menu, but are active nevertheless. Please be
careful when pressing keys so that you do not accidentally execute an unwanted command.

Press [W] from the Main Menu to warm boot (restart) the module. This command
will cause the program to exit and reload, refreshing configuration parameters
that must be set on program initialization. Only use this command if you must
force the module to re-boot.

Exiting the Program

Caution: Some of the commands available to you from this menu are designed for advanced
debugging and system testing only, and can cause the module to stop communicating with the
processor or with other devices, resulting in potential data loss or other failures. Only use these
commands if you are specifically directed to do so by ProSoft Technology Technical Support staff.
Some of these command keys are not listed on the menu, but are active nevertheless. Please be
careful when pressing keys so that you do not accidentally execute an unwanted command.

Press [Esc] to restart the module and force all drivers to be loaded. The module
will use the configuration stored in the module's Flash ROM to configure the
module.

This manual is related to the following products: