PLANET IKVM-16010 - Manual (Page 9)

8/16-Port IP KVM Switch
9 / 38
1.7 Buttons and Operations
There are 11 push buttons on the front panel. The operations described in below.
(1) The “BANK SELECT” is the Bank Select Button.
You can select to the required bank number by press the “BANK SELECT” button.
The current accessed bank will be displayed at the 7-Segment LED.
The bank select were from 1 to 8 and go back to 1 cycling. It will increase the bank number from the
current selected bank to the next bank if you pressed the “BANK SELECT” button once.
(2) The “1”, “2”, “3”, “4”, “5”, “6”, “7”, “8”, “9”, “0” are the port number select buttons
You can select to the required port number by
- Press the 2 digit port number to switch the port directly. For example if you are in port 1 now,
press “0” then “6” will switch to the port 6 immediately.
- Press the port number and wait for 2 seconds to switch the port. At this case, you can only
press single digit to select to the destination if the port number is between port 1 to port 9.
(3) If you pressed the invalid operation, the system will stay at the previous selected port.
(4) RESET: Press the “5” and “0” button simultaneously will restart the firmware of the IP KVM switch.
1.8 Back Panels
Flash Upgrade Port
Remote Console Port(CAT5 T-Module)
DC Power Jack
Local Console Keyboard/Mouse Ports
Daisy Chain In
Local Console VGA Port / Daisy Chain Out
Connector for each Host Port