PLANET IKVM-16010 - Manual (Page 22)

8/16-Port IP KVM Switch
22 / 38
4. On the upper left corner, the MAC addresses of the IKVM-8010 / IKVM-16010 are displayed. To manually
detect the MAC address again, press the button “Refresh Devices”. The displayed MAC address is the
same MAC address printed on the sticker placed on the bottom of the IKVM-8010 /16010. If the
IKVM-8010 / IKVM-16010 are connected via USB, it is classified as an USB device and an appropriate
drive letter is chosen for this device.
5. On the lower right corner of the window, there are two buttons: “Query Device” and “Setup Device”. Press
the “Query Device” button to display the preconfigured values of the network configuration. The values are
displayed in the text fields located above. If necessary, adjust the network settings according to your
requirement. To save the changes, enter “super” in the “Super user login” field and “pass” in the “Super
user password” field. Then press the “Setup Device“ button.
6. On the lower left Authentication field, you can change the super user password here. However, the super
user name is fixed to “super” and can’t be modified. The default super user password is “pass”. It is
recommended to change the super user password as soon as you get this device.
The Wireless LAN Configuration field is left for future enhancement.
4.3 Configuration via Serial Port
Using a serial terminal, the IKVM-8010 / IKVM-16010 have a serial line interface (host side). This connector
is compliant with the RS-232 serial line standard. The serial line has to be configured with the parameters
given as below.