PLANET IKVM-16010 - Manual (Page 13)

8/16-Port IP KVM Switch
2.2.2 3-in-1 VGA Cable Installation
Each computer port connector is HDDB15 type. The 3-in-1 VGA cable has a HDDB15 male connector at one
end. Plug it into computer port on the rear of KVM switch. The other end of input cable has three connectors:
a HDDB15 male type for computer video, a purple mini din 6-pin PS/2 connector for keyboard and a green
mini din 6-pin PS/2 connector for mouse. Plug these three connectors into the respective ports of computer.
Repeat the same procedure for all other computers.
(a) PS/2 computer --- Plug in PS/2 mouse connector to computer mouse port, the PS/2 keyboard connector
to computer keyboard port. Do not hot plug PS/2 port. If you must do that make sure PS/2 mouse first
then the PS/2 keyboard.
3-in-1 VGA cable
(b) USB computer --- connect PS/2-USB changer to PS/2 keyboard connector, then plug the changer into
available USB port. This single USB port can communicate both keyboard and mouse signals. It works as a
standard HID (Human Interface Device), no extra driver needed.
PS/2-USB Changer
3-in-1 VGA Cable and PS/2 to USB Changer
Note: It is recommended to power off all the computers and server before the installation. If we can
not turn off the computer, for PS/2 computer, please plug in T-dongle connectors in the
following order: firstly PS/2 mouse connector, secondly PS/2 keyboard connector, thirdly the
VGA connector to the computer.
13 / 38