PLANET ISG-101 - Manual (Page 4)

PLANET ISG-101 Internet Subscriber Gateway
2 Product Description
Chapter 2 provides illustrations of the front and rear panels of the ISG-101 and detailed
technical specifications including information about LEDs, connectors, cables, environmental
and compliance specifications.
2-1 Hardware
Outlook
Figure 2-1 ISG-101 Outlook
Front Panel
Figure2-2 ISG-101 Front Panel
1. Console Ports: Standard RS232 DB 9 female Connector for system configuration.
2. System LEDs: Power LED glows when the device is turned on.
3. LAN Port: crossover 10/100M Ethernet port connects to any Ethernet network.
4. LAN Port LEDs:
10 Link LED: glows when a 10M network is connected;
100 Link LED: glows when a 100M network is connected
Act LED: flash when there is a reception or transmission of data occurring.
5. WAN Port: parallel 10/100M Ethernet port connects to any Ethernet network.
6. WAN Port LEDs:
10 Link LED: glows when a 10M network is connected;
100 Link LED: glows when a 100M network is connected
Act LED: flash when there is a reception or transmission of data occurring.
Rear Panel
Figure 2-3 ISG-101 Rear Panel
1. AC Power Connector: Plug in the female connector of the provided power cord into the
ISG-101 rear panel socket, and the male terminal into a power outlet. Input voltages range
from 90~240 V.
2. System Fan/Vents: This fan is used to circulate air inside the ISG-101 and also to dissipate
heat. The vents on both sides also serve the same purpose. Do not block these openings,
and leave adequate space at the rear and sides of the device.
2-2 Technical Specifications
Hardware Specifications
Network Specification
IEE802.3 10BaseT Ethernet
IEE802.3u 100BasedTX Fast Ethernet
Supports 1024 users concurrently
Throughput: Line rate at 20Mbps
Connectors
Ethernet Port: Two RJ-45 connectors for 10/100M Ethernet port
Serial Port: 1 DB9 Female RS232 Console Interface
Power Requirement
Internal universal switching power supply
100-220 VAC, 50/60 Hz
Power Consumption: 5V, 15 Watts, 3 Amp.
8 9