PLANET WNAP-7350 - Manual (Page 45)

User Manual of WNAP-7350
-38-
1. Connect the LAN port of the WNAP-7350 to the POE port of the PoE Injector over an Ethernet cable.
2. Connect the PC to the LAN port of the PoE Injector over an Ethernet cable.
3. Plug one end of the power cord into the PoE Injector, and the other end in electrical socket.
4. Go to “Advanced-> Operation Mode” to configure it to AP Bridgemode.
Figure 5-3-19
In this mode, the wireless interface of the WNAP-7350 works as the WAN port.
To configure the Wireless Settings of AP Bridge Mode, please refer to the section
5.6 Wireless Settings .
5.3.3.3. Client Router (WISP)
In the Client Router mode, the WNAP-7350 has DHCP Server build inside that allows many LANs automatically
generate an IP address to share the same Internet. Connect an AP/WISP wirelessly and connect to LANs via
wired. The Client Router mode is acts completely opposite to the AP Router mode.
WDS Repeater Mode
Internet
WDS Repeater Mode
Clients Switch
Antenna
WNAP-7350
Antenna
Client
a/n a/n
PoE
LAN
Client
Internet
WISP Mode
Wireless Internet
Service Provider
Antenna
WNAP-7350
WISP Mode
a/n a/n