PLANET WNAP-6308 - Manual (Page 46)

User Manual of WNAP-6308
-36-
3. Plug one end of the power cord into the PoE Injector, and the other end in electrical socket.
4. Go to “Advanced-> Operation Mode” to configure it in AP Router Mode.
Figure 5-25 Operation Mode – AP Router
In this mode, the LAN2 of the WNAP-6308 works as the WAN port.
To configure the Wireless Settings of AP Router Mode, please refer to the section 5.6 Wireless Settings .
5.3.3.2. AP Bridge (AP+WDS)
In the Access Point mode with WDS function, the WNAP-6308 functions like a central connection for any
stations or clients. Stations and clients must configure the same SSID and Security Password to associate
within the range. The WNAP-6308 supports 2 different SSIDs to separate different clients at the same time.
Figure 5-26 Topology – WDS Repeater Mode
1. Connect the LAN port of the WNAP-6308 to the POE port of the PoE Injector over an Ethernet cable.
2. Connect the PC to the LAN port of the PoE Injector over an Ethernet cable.
3. Plug one end of the power cord into the PoE Injector, and the other end in electrical socket.
4. Go to “Advanced-> Operation Mode” to configure it to AP Bridge mode.