PLANET ICA-W7100 - Manual (Page 12)

720P Wireless IR PT IP Camera
ICA-W7100
- 12 -
damaging the card, please insert micro SD card before
powering on IP cam.
(Please refer to Appendix G: Micro SD Card Compatibility to
select your SD card)
Ethernet Port
Connecting to PC or hub/switch
Please use CAT-5 cable to connect the Network Camera to a
100Mbps Fast Ethernet network switch or hub. When the
RJ45 is connected and IP camera is on, the Orange LED will
light up and the Green LED will flash. If the RJ45 cable is
removed, both LEDs will be off.
Audio Out
Use 3.5mm audio cable to connect the external audio
amplifier to output voice.
Antenna
Connector
It is the RP-SMA female type that allows device to be
connected to the supplied antenna.
DI/DO
Digital input / output dry contacts
Connect to external peripherals by wire. Tighten or loosen the
screw gently to insert or release the wire.
Power Jack
The input power is 5V DC, 2A. ONLY use the power adapter
that comes with the package. Otherwise, the product may be
damaged.
Item Description
Reset button
This button is hidden in the pinhole. This button is used to
restore all the factory default settings.
To restore the device, please follow the steps below:
1. Power on IP camera and wait till it finishes the booting
process (about 1 minute).
2. Use a paper clip or other tiny tool to press the button for
about 10 seconds to restore to default settings, and reboot
again.
Bracket Hole
Reset Button